// 4. Print them. Case and OneKeeperPrint should probably be
// the same colour.
//
-// 5. Assemble the hinge.
+// 5. Assemble the hinge. After placing the parts in the appropirate
+// relative placement:
//
-// Cut short bits of wire
-// Push in with long bit of wire
-// Use gas flame to melt end of 2.85mm PLA
-// Dab
+// Use long bit of wire to ensure holes are lined up and proper
+// Cut four short bits of wire, using above as a guage
+//
+// Push two short bits into two holes on same side
+// Use long bit of wire to ensure properly in holes
+// Keep that side up so they don't fall out!
+//
+// For each of the two holes
+// Use 20-30cm hunk of 2.85mm PLA
+// Use gas flame to melt end until it catches fire (!)
+// Remove from flame, wave to extinguish, and quickly:
+// Dab end onto where hole is
+// As it congeals, use sidecutters to cut off by hole
+//
+// Repeat for two holes on other side
+// When cool, file down rough edges
//
// 6. In use:
//