chiark
/
gitweb
/
~ianmdlvl
/
reprap-play.git
/ commitdiff
commit
grep
author
committer
pickaxe
?
search:
re
summary
|
shortlog
|
log
|
commit
| commitdiff |
tree
raw
|
patch
|
inline
| side by side (parent:
4d2364d
)
updated instructions
author
Ian Jackson
<ijackson@chiark.greenend.org.uk>
Tue, 28 Aug 2012 19:35:03 +0000
(20:35 +0100)
committer
Ian Jackson
<ijackson@chiark.greenend.org.uk>
Tue, 28 Aug 2012 19:35:03 +0000
(20:35 +0100)
INSTRUCTIONS
patch
|
blob
|
history
diff --git
a/INSTRUCTIONS
b/INSTRUCTIONS
index 9b6aff005499986e9a6c9085811e337d787e97bc..58d095ab3e38c8702fedd97bdd2e60fa142f1b0d 100644
(file)
--- a/
INSTRUCTIONS
+++ b/
INSTRUCTIONS
@@
-7,27
+7,29
@@
To print:
* Select "connect" (make sure it's ttyUSB0 115200),
wait for printer to connect
* Turn on the hotend and bed heaters
* Select "connect" (make sure it's ttyUSB0 115200),
wait for printer to connect
* Turn on the hotend and bed heaters
- * "Load file", select the .stl file. It will be sliced.
- * "Load file", select the _export.gcode file. It will show up on the RHS.
- * "SD" / "Upload", accept the suggested filename (but remember it)
- and when it is done, turn on the hotend and bed heaters again
- * Home all
- * Pick ooze off nozzle with fine-nosed pliers
+ * Remove MicroSD card from printer and copy the file to it
+ (give it an 8.3 filename ending in .G)
+ * Insert MicroSD card back into printer
* Wait for bed (and hotend) to get up to temperature
* Wait for bed (and hotend) to get up to temperature
- *
Pick ooze
off nozzle with fine-nosed pliers
+ *
If there's lots of ooze, pick
off nozzle with fine-nosed pliers
* "SD" / "Print", select the file you uploaded earlier
* "SD" / "Print", select the file you uploaded earlier
- * While waiting for it to start (~1min?)
- pick ooze off nozzle with fine-nosed pliers
* Watch while it starts and make sure that the skirt sticks to
printbed and nothing gets tangled
* Check that filament feed path from feedstock coil looks good.
------------------------------------------------------------
* Watch while it starts and make sure that the skirt sticks to
printbed and nothing gets tangled
* Check that filament feed path from feedstock coil looks good.
------------------------------------------------------------
+make these symlinks
~/.pronsolerc -> /home/ian/things/Reprap/play/pronsolerc (adjust to taste)
openscad - use wheezy
~/.pronsolerc -> /home/ian/things/Reprap/play/pronsolerc (adjust to taste)
openscad - use wheezy
-Slic3r - is from slic3r-linux-x86-0-8-4.tar.gz
+ie
+ schroot -pc wheezy
+ openscad
+or
+ schroot -pc wheezy openscad
+
+Slic3r - is from slic3r-linux-x86-0-9-1.tar.gz
repsnapper - only used this so far for its gcode viewer
repsnapper - only used this so far for its gcode viewer