From 629359238b2938366dc6e526d30a2a7ddec5a1b0 Mon Sep 17 00:00:00 2001 From: Ian Jackson Date: Wed, 2 Mar 2022 23:42:42 +0000 Subject: [PATCH] fairphone4-case-mount: Improved hinge assembly instructions Signed-off-by: Ian Jackson --- fairphone4-case.scad | 23 ++++++++++++++++++----- 1 file changed, 18 insertions(+), 5 deletions(-) diff --git a/fairphone4-case.scad b/fairphone4-case.scad index d3315f1..1738612 100644 --- a/fairphone4-case.scad +++ b/fairphone4-case.scad @@ -23,12 +23,25 @@ // 4. Print them. Case and OneKeeperPrint should probably be // the same colour. // -// 5. Assemble the hinge. +// 5. Assemble the hinge. After placing the parts in the appropirate +// relative placement: // -// Cut short bits of wire -// Push in with long bit of wire -// Use gas flame to melt end of 2.85mm PLA -// Dab +// Use long bit of wire to ensure holes are lined up and proper +// Cut four short bits of wire, using above as a guage +// +// Push two short bits into two holes on same side +// Use long bit of wire to ensure properly in holes +// Keep that side up so they don't fall out! +// +// For each of the two holes +// Use 20-30cm hunk of 2.85mm PLA +// Use gas flame to melt end until it catches fire (!) +// Remove from flame, wave to extinguish, and quickly: +// Dab end onto where hole is +// As it congeals, use sidecutters to cut off by hole +// +// Repeat for two holes on other side +// When cool, file down rough edges // // 6. In use: // -- 2.30.2