+++ /dev/null
-To print:
-
- * Turn on printer and connect computer.
- * Start pronterface
- cd /home/reprap/reprappro-software.git/
- ./pronterface.py
- * Select "connect" (make sure it's ttyUSB0 115200),
- wait for printer to connect
- * Turn on the hotend and bed heaters
- * Remove MicroSD card from printer and copy the file to it
- (give it an 8.3 filename ending in .G)
- * Insert MicroSD card back into printer
- * Wait for bed (and hotend) to get up to temperature
- * If there's lots of ooze, pick off nozzle with fine-nosed pliers
- * "SD" / "Print", select the file you uploaded earlier
- * Watch while it starts and make sure that the skirt sticks to
- printbed and nothing gets tangled
- * Check that filament feed path from feedstock coil looks good.
-
-------------------------------------------------------------
-
-make these symlinks
-~/.pronsolerc -> /home/ian/things/Reprap/play/pronsolerc (adjust to taste)
-
-openscad - use wheezy
-ie
- schroot -pc wheezy
- openscad
-or
- schroot -pc wheezy openscad
-
-Slic3r - is from slic3r-linux-x86-0-9-1.tar.gz
- /home/reprap/Slic3r/bin/slic3r --load /home/reprap/play/slic3r-config.ini --ignore-nonexistent-config
-
-repsnapper - only used this so far for its gcode viewer
-
-------------------------------------------------------------
-
-firmware upgrade:
-
- firmware is in marlin.git#iwj and works with make
- various other firmwares for comparison only
- sprinter-reprappro.git sprinter.git
- produces Marlin.hex
- depends on stuff in arduino-0022 (doesn't work with other arduino
- versions, incompatible)
- program with
- avrdude -b 38400 -v -P /dev/ttyUSB0 -p atmega644P -c arduino -U flash:w:Marlin.hex
- needs the reset jumper (which is right next to the mcu) fitted