foldover_lever_gap = 0.50;
// properties of the hinge fasteners
-hingescrew_shaft_dia = 2.0 + 0.25; // M2 x 12mm machine screw
-hingescrew_shaft_len = 12;
+hingescrew_shaft_dia = 1.600 + 0.45; // beading wire
+hingescrew_shaft_len = 10;
hingescrew_fasteners_extra_thick = 0.40;
// ^ amount of thread protruding if everything was completely nominal
// and we are using two nuts
hinge_x_postscrew_gap = 0.75;
hinge_x_arms_gap = 0.35;
hinge_r_arms_gap = 0.55;
-hinge_over_nut_plate = 1.0;
+hinge_over_nut_plate = -0.50; // bodge apropos slope
// there isn't one of these, speaker is by hinge
// rearspeaker_gap = [ 2.0, 2.0 ]; // each side
HingeLeverOuterProfile();
// space for the screws
- HingePortion(hex26, hex24)
- HingeLeverInnerProfile();
+// HingePortion(hex26, hex24)
+// HingeLeverInnerProfile();
// recesses for the nuts
- HingePortion(hex23, hex26+1)
- HingeLeverNutProfile();
+// HingePortion(hex23, hex26+1)
+// HingeLeverNutProfile();
// bores for the screws
HingeScrews();