2 multiplex should have restart loop limiting
3 why did removing +persist.* not fix it
4 version number should be reported / preserved somehow
5 should expire dumps, eventually
6 want realtime kernel for bessar
10 at converging points eg X8, can we make train
11 go from (say) X6 fast enough that when we stop
12 it it fouls the dynamic envelope for X4-X8
13 but doesn't enter X8 and thus signalling system
17 speedw-redisplay-speed can crash reading unset variable
18 gcommanded when trying to switch away from current
19 train after realtime crashed; presumably some state
20 is not properly sorted out ?
22 allegedly fixed, but untested
23 current set of stuff on liberator
24 liberator:trains> rsync -vPI bessar:/bessar/bessar/playground/+dump.2008-07-28T00-02-43+0100/* hostside/
25 * wrongly says santafe impeded by shinkansen when
26 we try to reverse it (look from tail of log)
27 * when we tell it to go it has a fit about A2
29 if train was abutting section boundary and is told to go,
30 maxinto is not updated properly, so if it is then
31 told to stop it stops owning the segment it may have
33 to reproduce: put shinkansen nose car at A6 (home location)
34 and nothing else. command speed 1 then speed 0
35 should now own X12 too but does not
38 does not set serial port mode etc.
39 when checking future polarity possibility, does not account
40 for MARGIN_POLARISETIME - it just checks to see if
41 extending front before reducing rear is sufficient
42 this will not work if there are segments which are
43 traversed more quickly than MARGIN_POLARISETIME
45 movpos++ when under train does not work - is ignored and gives ok
48 stop all trains command ?
49 stop and turn off calmly when ^D
50 why FAULT reported when power is turned off ?
52 things not yet considered at all in safety code:
53 min. curve specifications
55 would be nice to do something with POINTED