X-Git-Url: http://www.chiark.greenend.org.uk/ucgi/~ianmdlvl/git?p=reprap-play.git;a=blobdiff_plain;f=INSTRUCTIONS;h=93ec36b03d3daf858f077f3016710e75b509171c;hp=9b6aff005499986e9a6c9085811e337d787e97bc;hb=4fb988a551049dac5f11f562415340d8743dd8e5;hpb=8829dcf87991b98db0d18e376c1db66019d4e454

diff --git a/INSTRUCTIONS b/INSTRUCTIONS
index 9b6aff0..93ec36b 100644
--- a/INSTRUCTIONS
+++ b/INSTRUCTIONS
@@ -7,27 +7,30 @@ To print:
  * Select "connect" (make sure it's ttyUSB0 115200),
    wait for printer to connect
  * Turn on the hotend and bed heaters
- * "Load file", select the .stl file.  It will be sliced.
- * "Load file", select the _export.gcode file.  It will show up on the RHS.
- * "SD" / "Upload", accept the suggested filename (but remember it)
-   and when it is done, turn on the hotend and bed heaters again
- * Home all
- * Pick ooze off nozzle with fine-nosed pliers
+ * Remove MicroSD card from printer and copy the file to it
+   (give it an 8.3 filename ending in .G)
+ * Insert MicroSD card back into printer
  * Wait for bed (and hotend) to get up to temperature
- * Pick ooze off nozzle with fine-nosed pliers
+ * If there's lots of ooze, pick off nozzle with fine-nosed pliers
  * "SD" / "Print", select the file you uploaded earlier
- * While waiting for it to start (~1min?)
-   pick ooze off nozzle with fine-nosed pliers
  * Watch while it starts and make sure that the skirt sticks to
    printbed and nothing gets tangled
  * Check that filament feed path from feedstock coil looks good.
 
 ------------------------------------------------------------
 
+make these symlinks
 ~/.pronsolerc -> /home/ian/things/Reprap/play/pronsolerc (adjust to taste)
 
 openscad - use wheezy
-Slic3r - is from slic3r-linux-x86-0-8-4.tar.gz
+ie
+  schroot -pc wheezy
+     openscad
+or
+  schroot -pc wheezy openscad
+
+Slic3r - is from slic3r-linux-x86-0-9-1.tar.gz
+ /home/reprap/Slic3r/bin/slic3r --load /home/reprap/play/slic3r-config.ini --ignore-nonexistent-config
 
 repsnapper - only used this so far for its gcode viewer