* Watch while it starts and make sure that the skirt sticks to
printbed and nothing gets tangled
* Check that filament feed path from feedstock coil looks good.
+
+------------------------------------------------------------
+
+openscad - use wheezy
+Slic3r - is from slic3r-linux-x86-0-8-4.tar.gz
+
+------------------------------------------------------------
+
+firmware upgrade:
+
+ firmware is in marlin.git#iwj and works with make
+ various other firmwares for comparison only
+ sprinter-reprappro.git sprinter.git
+ produces Marlin.hex
+ depends on stuff in arduino-0022 (doesn't work with other arduino
+ versions, incompatible)
+ program with
+ avrdude -b 38400 -v -P /dev/ttyUSB0 -p atmega644P -c arduino -U flash:w:Marlin.hex
+ needs the reset jumper (which is right next to the mcu) fitted