unit: replace remote-fs-setup.target by network-online.target

[elogind.git] / NEWS

diff --git a/NEWS b/NEWS
index 8815ce9c4ed10f3378f14914f1ec2a2e2a12348c..8396c312bd1063155b7ed14a90b05348c4ff0326 100644 (file)
--- a/NEWS
+++ b/NEWS
@@ -14,7 +14,7 @@ CHANGES WITH 199:
           ExecStartPre= may now leave data in /tmp that ExecStart= of
           the same service can still access). When a service is
           stopped its temporary directories are immediately deleted
-          (normal clean-up with tmpfiles still is done in addition to
+          (normal clean-up with tmpfiles is still done in addition to
           this though).
 
         * By default, systemd will now set a couple of sysctl
@@ -25,18 +25,18 @@ CHANGES WITH 199:
           be reasonably safe, and good defaults for all new systems.
 
         * The predictable network naming logic may now be turned off
-          with a new kernel command line switch: net.ifnames=0
+          with a new kernel command line switch: net.ifnames=0.
 
         * A new libsystemd-bus module has been added that implements a
           pretty complete D-Bus client library. For details see:
 
           http://lists.freedesktop.org/archives/systemd-devel/2013-March/009797.html
 
-        * journald will not explicitly flush the journal files to disk
-          the latest 5min after each write. This will also mark the
-          files as offline then until the next read. This should
-          increase reliability. The synchronization delay can be
-          configured via SyncIntervalSec= in journald.conf.
+        * journald will now explicitly flush the journal files to disk
+          at the latest 5min after each write. The file will then also
+          be marked offline until the next write. This should increase
+          reliability in case of a crash. The synchronization delay
+          can be configured via SyncIntervalSec= in journald.conf.
 
         * There's a new remote-fs-setup.target unit that can be used
           to pull in specific services when at least one remote file
@@ -47,6 +47,15 @@ CHANGES WITH 199:
           from. This complements sockets.target with a similar
           purpose for socket units.
 
+        * libudev gained a new call udev_device_set_attribute_value()
+          to set sysfs attributes of a device.
+
+        * The udev daemon now sets the default number of worker
+          processes executed in parallel based on the number of available
+          CPUs instead of the amount of available RAM. This is supposed
+          to provide a more reliable default and limit a too agressive
+          paralellism for setups with 1000s of devices connected.
+
         Contributions from: Auke Kok, Colin Walters, Cristian
         Rodríguez, Daniel Buch, Dave Reisner, Frederic Crozat, Hannes
         Reinecke, Harald Hoyer, Jan Alexander Steffens, Jan