+Development
+* Added an expert parameter for the wipe tower size, and made brim go around the wipe tower
+* Added experimental support for printing with the Doodle3D WiFi box
+* Updated object boundaries for multi-object prints, allows for tighter fitting of objects on the build platform
+* Updated time-estimate to greatly improve accuracy of the estimate.
+* Fixed problem with retractions not happening when they should.
+
+Ultimaker2 - Firmware update - 13.12
+* Fixed the problem where aborting a print did not always home the head.
+* Fixed bug in acceleration planning causing slow moves on rare occasions.
+* Disable the normal menus during USB printing, and support for USB based menus.
+* Expert feature: Support M907 for setting the motor current.
+
+Ultimaker Original - Firmware update - 13.12
+* Fixed bug in acceleration planning causing slow moves on rare occasions.
+* Updated to new ErikZalm Marlin base, fixing the long standing slower retraction bug.
+
+13.11.2
+* Adjusted the gantry height to 55mm for the Ultimaker, as 60mm was 3mm to high for the default setup with an V2 hotend.
+* Added disallowed zones for UM2
+* Added ooze-shield for dual-color printing
+* Added wipe tower for dual-extrusion
+* Added no-go zones for UM2 glass clips
+
+Ultimaker2 - Firmware update - 13.11-2
+* Fixed UM2 build volume offset so that you do not print off the glass plate.
+* Slightly tweaked the filament change procedure so there is less chance of a blob staying behind.
+* Slightly tweaked the SD-Card error problems.
+* Added LED settings to Tune menu
+* Start heating the nozzles when the bed is nearing its final temperature, so the nozzles do not sit hot.
+* Make sure all commands are finished before starting a print or changing material. This could cause issues when you where too fast.
+
+13.11
+* Added imageToMesh tool to load images as 3D height maps
+* Fixed Z support distance when using "everywhere" support.
+* Updated to new version of clipper to fix rare slicing bugs that resulted in odd paths.
+* Fixed "Reset profile" so it no longer resets the machine settings.
+* Updated support material so support is smoother and has less small sections which are hard to remove.
+* Fixed start-gcode when using dual-support material
+* Change how the fan is handled on lower layer to improve UM2 printing.
+* Fix that retraction is enabled when selecting UM2 or RepRap.
+* Scale down very large models, or scale up very tiny models automagicly.
+* Fixed skirt and brim to go around the support instead of under it.
+* Added spiralize mode
+
+Ultimaker2 - Firmware update - 13.10-5
+* Fixed SD-Card read error
+* Added feature to store your own material presets
+* Fixed the 280C ABS problem, causing a temperature sensor error
+
+13.10
+* Added YouMagine upload button
+* Added multiple machine support
+* Redone support material
~ianmdlvl / cura.git / blobdiff