Allow for odd shaped platforms and generalize the UM2 clip code into no-go zones.

[cura.git] / changelog

diff --git a/changelog b/changelog
index 9b89c06357cf4365b24e521ffc0f47f576103583..3e4aa38ff5a36b12f0d229e0d839c0bd926088ff 100644 (file)
--- a/changelog
+++ b/changelog
@@ -1,6 +1,19 @@
 Development
+
+13.11.2
 * Adjusted the gantry height to 55mm for the Ultimaker, as 60mm was 3mm to high for the default setup with an V2 hotend.
+* Added disallowed zones for UM2
+* Added ooze-shield for dual-color printing
+* Added wipe tower for dual-extrusion
+* Added no-go zones for UM2 glass clips
 
+Ultimaker2 - Firmware update - 13.11-2
+* Fixed UM2 build volume offset so that you do not print off the glass plate.
+* Slightly tweaked the filament change procedure so there is less chance of a blob staying behind.
+* Slightly tweaked the SD-Card error problems.
+* Added LED settings to Tune menu
+* Start heating the nozzles when the bed is nearing its final temperature, so the nozzles do not sit hot.
+* Make sure all commands are finished before starting a print or changing material. This could cause issues when you where too fast.
 
 13.11
 * Added imageToMesh tool to load images as 3D height maps