Allow for odd shaped platforms and generalize the UM2 clip code into no-go zones.

[cura.git] / changelog

diff --git a/changelog b/changelog
index 0e7012ba7a0782548d1b35a9e0c23f796d8d65bc..3e4aa38ff5a36b12f0d229e0d839c0bd926088ff 100644 (file)
--- a/changelog
+++ b/changelog
@@ -1,4 +1,21 @@
 Development
+
+13.11.2
+* Adjusted the gantry height to 55mm for the Ultimaker, as 60mm was 3mm to high for the default setup with an V2 hotend.
+* Added disallowed zones for UM2
+* Added ooze-shield for dual-color printing
+* Added wipe tower for dual-extrusion
+* Added no-go zones for UM2 glass clips
+
+Ultimaker2 - Firmware update - 13.11-2
+* Fixed UM2 build volume offset so that you do not print off the glass plate.
+* Slightly tweaked the filament change procedure so there is less chance of a blob staying behind.
+* Slightly tweaked the SD-Card error problems.
+* Added LED settings to Tune menu
+* Start heating the nozzles when the bed is nearing its final temperature, so the nozzles do not sit hot.
+* Make sure all commands are finished before starting a print or changing material. This could cause issues when you where too fast.
+
+13.11
 * Added imageToMesh tool to load images as 3D height maps
 * Fixed Z support distance when using "everywhere" support.
 * Updated to new version of clipper to fix rare slicing bugs that resulted in odd paths.
@@ -9,8 +26,9 @@ Development
 * Fix that retraction is enabled when selecting UM2 or RepRap.
 * Scale down very large models, or scale up very tiny models automagicly.
 * Fixed skirt and brim to go around the support instead of under it.
+* Added spiralize mode
 
-Ultimaker2 - Firmware update - xx.xx-xx
+Ultimaker2 - Firmware update - 13.10-5
 * Fixed SD-Card read error
 * Added feature to store your own material presets
 * Fixed the 280C ABS problem, causing a temperature sensor error