setting('retraction_dual_amount', 16.5, float, 'advanced', _('Retraction')).setRange(0).setLabel(_("Dual extrusion switch amount (mm)"), _("Amount of retraction when switching nozzle with dual-extrusion, set at 0 for no retraction at all. A value of 16.0mm seems to generate good results."))
setting('retraction_min_travel', 1.5, float, 'expert', _('Retraction')).setRange(0).setLabel(_("Minimum travel (mm)"), _("Minimum amount of travel needed for a retraction to happen at all. To make sure you do not get a lot of retractions in a small area."))
setting('retraction_combing', True, bool, 'expert', _('Retraction')).setLabel(_("Enable combing"), _("Combing is the act of avoiding holes in the print for the head to travel over. If combing is disabled the printer head moves straight from the start point to the end point and it will always retract."))
-setting('retraction_minimal_extrusion',0.1, float,'expert', _('Retraction')).setRange(0).setLabel(_("Minimal extrusion before retracting (mm)"), _("The minimal amount of extrusion that needs to be done before retracting again if a retraction needs to happen before this minimal is reached the retraction is ignored.\nThis avoids retraction a lot on the same piece of filament which flattens the filament and causes grinding issues."))
+setting('retraction_minimal_extrusion',0.02, float,'expert', _('Retraction')).setRange(0).setLabel(_("Minimal extrusion before retracting (mm)"), _("The minimal amount of extrusion that needs to be done before retracting again if a retraction needs to happen before this minimal is reached the retraction is ignored.\nThis avoids retraction a lot on the same piece of filament which flattens the filament and causes grinding issues."))
setting('bottom_thickness', 0.3, float, 'advanced', _('Quality')).setRange(0).setLabel(_("Initial layer thickness (mm)"), _("Layer thickness of the bottom layer. A thicker bottom layer makes sticking to the bed easier. Set to 0.0 to have the bottom layer thickness the same as the other layers."))
setting('object_sink', 0.0, float, 'advanced', _('Quality')).setLabel(_("Cut off object bottom (mm)"), _("Sinks the object into the platform, this can be used for objects that do not have a flat bottom and thus create a too small first layer."))
#setting('enable_skin', False, bool, 'advanced', _('Quality')).setLabel(_("Duplicate outlines"), _("Skin prints the outer lines of the prints twice, each time with half the thickness. This gives the illusion of a higher print quality."))
~ianmdlvl / cura.git / blobdiff