setting('solid_bottom', True, bool, 'expert', _('Infill')).setLabel(_("Solid infill bottom"), _("Create a solid bottom surface, if set to false the bottom is filled with the fill percentage. Useful for buildings."))
setting('fill_overlap', 15, int, 'expert', _('Infill')).setRange(0,100).setLabel(_("Infill overlap (%)"), _("Amount of overlap between the infill and the walls. There is a slight overlap with the walls and the infill so the walls connect firmly to the infill."))
setting('support_type', 'Lines', ['Grid', 'Lines'], 'expert', _('Support')).setLabel(_("Structure type"), _("The type of support structure.\nGrid is very strong and can come off in 1 piece, however, sometimes it is too strong.\nLines are single walled lines that break off one at a time. Which is more work to remove, but as it is less strong it does work better on tricky prints."))
-setting('support_angle', 60, float, 'expert', _('Support')).setRange(0,90).setLabel(_("Overhang angle for support (deg)"), _("The minimal angle that overhangs need to have to get support. With 90 degree being horizontal and 0 degree being vertical."))
+setting('support_angle', 60, float, 'expert', _('Support')).setRange(0,90).setLabel(_("Overhang angle for support (deg)"), _("The minimal angle that overhangs need to have to get support. Setting this to 0 degrees means every overhang will be supported. 90 degrees effectively disables support."))
setting('support_fill_rate', 15, int, 'expert', _('Support')).setRange(0,100).setLabel(_("Fill amount (%)"), _("Amount of infill structure in the support material, less material gives weaker support which is easier to remove. 15% seems to be a good average."))
setting('support_xy_distance', 0.7, float, 'expert', _('Support')).setRange(0,10).setLabel(_("Distance X/Y (mm)"), _("Distance of the support material from the print, in the X/Y directions.\n0.7mm gives a nice distance from the print so the support does not stick to the print."))
setting('support_z_distance', 0.15, float, 'expert', _('Support')).setRange(0,10).setLabel(_("Distance Z (mm)"), _("Distance from the top/bottom of the support to the print. A small gap here makes it easier to remove the support but makes the print a bit uglier.\n0.15mm gives a good seperation of the support material."))
~ianmdlvl / cura.git / blobdiff