From 5bda92f43132b945d9d0cacef0b111304eb137df Mon Sep 17 00:00:00 2001 From: nickthetait Date: Mon, 5 Oct 2015 12:10:55 -0600 Subject: [PATCH] Improve overhang text description --- Cura/util/profile.py | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/Cura/util/profile.py b/Cura/util/profile.py index e71018f4..dcd78cc7 100644 --- a/Cura/util/profile.py +++ b/Cura/util/profile.py @@ -234,7 +234,7 @@ setting('solid_top', True, bool, 'expert', _('Infill')).setLabel(_("Solid infill setting('solid_bottom', True, bool, 'expert', _('Infill')).setLabel(_("Solid infill bottom"), _("Create a solid bottom surface, if set to false the bottom is filled with the fill percentage. Useful for buildings.")) setting('fill_overlap', 15, int, 'expert', _('Infill')).setRange(0,100).setLabel(_("Infill overlap (%)"), _("Amount of overlap between the infill and the walls. There is a slight overlap with the walls and the infill so the walls connect firmly to the infill.")) setting('support_type', 'Lines', ['Grid', 'Lines'], 'expert', _('Support')).setLabel(_("Structure type"), _("The type of support structure.\nGrid is very strong and can come off in 1 piece, however, sometimes it is too strong.\nLines are single walled lines that break off one at a time. Which is more work to remove, but as it is less strong it does work better on tricky prints.")) -setting('support_angle', 60, float, 'expert', _('Support')).setRange(0,90).setLabel(_("Overhang angle for support (deg)"), _("The minimal angle that overhangs need to have to get support. With 90 degree being horizontal and 0 degree being vertical.")) +setting('support_angle', 60, float, 'expert', _('Support')).setRange(0,90).setLabel(_("Overhang angle for support (deg)"), _("The minimal angle that overhangs need to have to get support. Setting this to 0 degrees means every overhang will be supported. 90 degrees effectively disables support.")) setting('support_fill_rate', 15, int, 'expert', _('Support')).setRange(0,100).setLabel(_("Fill amount (%)"), _("Amount of infill structure in the support material, less material gives weaker support which is easier to remove. 15% seems to be a good average.")) setting('support_xy_distance', 0.7, float, 'expert', _('Support')).setRange(0,10).setLabel(_("Distance X/Y (mm)"), _("Distance of the support material from the print, in the X/Y directions.\n0.7mm gives a nice distance from the print so the support does not stick to the print.")) setting('support_z_distance', 0.15, float, 'expert', _('Support')).setRange(0,10).setLabel(_("Distance Z (mm)"), _("Distance from the top/bottom of the support to the print. A small gap here makes it easier to remove the support but makes the print a bit uglier.\n0.15mm gives a good seperation of the support material.")) -- 2.30.2