enable raft is depricated.

diff --git a/Cura/util/profile.py b/Cura/util/profile.py
index 6c97d3c224252aa94216ab8e5a27fa11d41d9f71..5a206c71dda29a7043c68b8756fe0aa6701b97f3 100644 (file)
--- a/Cura/util/profile.py
+++ b/Cura/util/profile.py
@@ -126,7 +126,6 @@ setting('print_temperature4',          0, int,   'basic',    'Speed & Temperatur
 setting('print_bed_temperature',      70, int,   'basic',    'Speed & Temperature').setRange(0,340).setLabel('Bed temperature (C)', 'Temperature used for the heated printer bed. Set at 0 to pre-heat yourself.')
 setting('support',                'None', ['None', 'Touching buildplate', 'Everywhere'], 'basic', 'Support').setLabel('Support type', 'Type of support structure build.\n"Touching buildplate" is the most commonly used support setting.\n\nNone does not do any support.\nTouching buildplate only creates support where the support structure will touch the build platform.\nEverywhere creates support even on top of parts of the model.')
 setting('platform_adhesion',      'None', ['None', 'Brim', 'Raft'], 'basic', 'Support').setLabel('Platform adhesion type', 'Different options that help in preventing corners from lifting due to warping.\nBrim adds a single layer thick flat area around your object which is easy to cut off afterwards, and the recommended option.\nRaft adds a thick raster at below the object and a thin interface between this and your object.\n(Note that enabling the brim or raft disables the skirt)')
-#setting('enable_raft',             False, bool,  'basic',   'Support').setLabel('Enable raft', 'A raft is a few layers of lines below the bottom of the object. It prevents warping. Full raft settings can be found in the expert settings.\nFor PLA this is usually not required. But if you print with ABS it is almost required.')
 setting('support_dual_extrusion',  False, bool, 'basic', 'Support').setLabel('Support dual extrusion', 'Print the support material with the 2nd extruder in a dual extrusion setup. The primary extruder will be used for normal material, while the second extruder is used to print support material.')
 setting('filament_diameter',        2.89, float, 'basic',    'Filament').setRange(1).setLabel('Diameter (mm)', 'Diameter of your filament, as accurately as possible.\nIf you cannot measure this value you will have to calibrate it, a higher number means less extrusion, a smaller number generates more extrusion.')
 setting('filament_diameter2',          0, float, 'basic',    'Filament').setRange(0).setLabel('Diameter2 (mm)', 'Diameter of your filament for the 2nd nozzle. Use 0 to use the same diameter as for nozzle 1.')