X-Git-Url: http://www.chiark.greenend.org.uk/ucgi/~ianmdlvl/git?a=blobdiff_plain;f=changelog;h=3e4aa38ff5a36b12f0d229e0d839c0bd926088ff;hb=6f5fe9dff6f3fd29546d46e5a67ef40ec285dcc6;hp=51c22ca805fda77b5816d0c5791b23146e2eb91c;hpb=7370ced53db760553cf01b040d8b1260a8681035;p=cura.git

diff --git a/changelog b/changelog
index 51c22ca8..3e4aa38f 100644
--- a/changelog
+++ b/changelog
@@ -1,14 +1,37 @@
 Development
+
+13.11.2
+* Adjusted the gantry height to 55mm for the Ultimaker, as 60mm was 3mm to high for the default setup with an V2 hotend.
+* Added disallowed zones for UM2
+* Added ooze-shield for dual-color printing
+* Added wipe tower for dual-extrusion
+* Added no-go zones for UM2 glass clips
+
+Ultimaker2 - Firmware update - 13.11-2
+* Fixed UM2 build volume offset so that you do not print off the glass plate.
+* Slightly tweaked the filament change procedure so there is less chance of a blob staying behind.
+* Slightly tweaked the SD-Card error problems.
+* Added LED settings to Tune menu
+* Start heating the nozzles when the bed is nearing its final temperature, so the nozzles do not sit hot.
+* Make sure all commands are finished before starting a print or changing material. This could cause issues when you where too fast.
+
+13.11
 * Added imageToMesh tool to load images as 3D height maps
 * Fixed Z support distance when using "everywhere" support.
 * Updated to new version of clipper to fix rare slicing bugs that resulted in odd paths.
 * Fixed "Reset profile" so it no longer resets the machine settings.
-* Updated support material so support is smoother and has less small sections.
+* Updated support material so support is smoother and has less small sections which are hard to remove.
 * Fixed start-gcode when using dual-support material
 * Change how the fan is handled on lower layer to improve UM2 printing.
 * Fix that retraction is enabled when selecting UM2 or RepRap.
 * Scale down very large models, or scale up very tiny models automagicly.
-* 
+* Fixed skirt and brim to go around the support instead of under it.
+* Added spiralize mode
+
+Ultimaker2 - Firmware update - 13.10-5
+* Fixed SD-Card read error
+* Added feature to store your own material presets
+* Fixed the 280C ABS problem, causing a temperature sensor error
 
 13.10
 * Added YouMagine upload button