Fix the wrong layer for fan fully on.

[cura.git] / changelog

diff --git a/changelog b/changelog
index 51c22ca805fda77b5816d0c5791b23146e2eb91c..9b89c06357cf4365b24e521ffc0f47f576103583 100644 (file)
--- a/changelog
+++ b/changelog
@@ -1,14 +1,24 @@
 Development
+* Adjusted the gantry height to 55mm for the Ultimaker, as 60mm was 3mm to high for the default setup with an V2 hotend.
+
+
+13.11
 * Added imageToMesh tool to load images as 3D height maps
 * Fixed Z support distance when using "everywhere" support.
 * Updated to new version of clipper to fix rare slicing bugs that resulted in odd paths.
 * Fixed "Reset profile" so it no longer resets the machine settings.
-* Updated support material so support is smoother and has less small sections.
+* Updated support material so support is smoother and has less small sections which are hard to remove.
 * Fixed start-gcode when using dual-support material
 * Change how the fan is handled on lower layer to improve UM2 printing.
 * Fix that retraction is enabled when selecting UM2 or RepRap.
 * Scale down very large models, or scale up very tiny models automagicly.
-* 
+* Fixed skirt and brim to go around the support instead of under it.
+* Added spiralize mode
+
+Ultimaker2 - Firmware update - 13.10-5
+* Fixed SD-Card read error
+* Added feature to store your own material presets
+* Fixed the 280C ABS problem, causing a temperature sensor error
 
 13.10
 * Added YouMagine upload button