Development
+
+13.11.2
+* Adjusted the gantry height to 55mm for the Ultimaker, as 60mm was 3mm to high for the default setup with an V2 hotend.
+* Added disallowed zones for UM2
+* Added ooze-shield for dual-color printing
+* Added wipe tower for dual-extrusion
+* Added no-go zones for UM2 glass clips
+
+Ultimaker2 - Firmware update - 13.11-2
+* Fixed UM2 build volume offset so that you do not print off the glass plate.
+* Slightly tweaked the filament change procedure so there is less chance of a blob staying behind.
+* Slightly tweaked the SD-Card error problems.
+* Added LED settings to Tune menu
+* Start heating the nozzles when the bed is nearing its final temperature, so the nozzles do not sit hot.
+* Make sure all commands are finished before starting a print or changing material. This could cause issues when you where too fast.
+
+13.11
* Added imageToMesh tool to load images as 3D height maps
* Fixed Z support distance when using "everywhere" support.
* Updated to new version of clipper to fix rare slicing bugs that resulted in odd paths.
* Fixed skirt and brim to go around the support instead of under it.
* Added spiralize mode
-Ultimaker2 - Firmware update - 13.10-3
+Ultimaker2 - Firmware update - 13.10-5
* Fixed SD-Card read error
* Added feature to store your own material presets
* Fixed the 280C ABS problem, causing a temperature sensor error