- Udev creates and removes device nodes in /dev, based on events the kernel
- sends out on device discovery or removal.
-
- - Very early in the boot process, the /dev directory should get a 'tmpfs'
- filesystem mounted, which is populated from scratch by udev. Created nodes
- or changed permissions will not survive a reboot, which is intentional.
-
- - The content of /lib/udev/devices directory which contains the nodes,
- symlinks and directories, which are always expected to be in /dev, should
- be copied over to the tmpfs mounted /dev, to provide the required nodes
- to initialize udev and continue booting.
-
- - The old hotplug helper /sbin/hotplug should be disabled on bootup, before
- actions like loading kernel modules are taken, which may cause a lot of
- events.
-
- - The udevd daemon must be started on bootup to receive netlink uevents
- from the kernel driver core.
-
- - All kernel events are matched against a set of specified rules in
- /etc/udev/rules.d/ which make it possible to hook into the event
- processing to load required kernel modules and setup devices. For all
- devices the kernel exports a major/minor number, udev will create a
- device node with the default kernel name, or the one specified by a
- matching udev rule.
-
-
-Compile Options:
- DESTDIR
- Prefix of install target, used for package building.
- USE_LOG
- If set to 'true', udev is able to pass errors or debug information
- to syslog. This is very useful to see what udev is doing or not doing.
- It is enabled by default, don't expect any useful answer, if you
- need to hunt a bug, but you can't enable syslog.
- DEBUG
- If set to 'true', very verbose debugging messages will be compiled
- into the udev binaries. The actual level of debugging is specified
- in the udev config file.
- USE_SELINUX
- If set to 'true', udev will be built with SELinux support
- enabled. This is disabled by default.
- EXTRAS
- list of helper programs in extras/ to build.
- make EXTRAS="extras/cdrom_id extras/scsi_id extras/volume_id"
-
-
-Installation:
- - The install target intalls the udev binaries in the default locations,
- All binaries will be installed in /lib/udev or /sbin.
-
- - The default location for scripts and binaries that are called from
- rules is /lib/udev. Other packages who install udev rules, may use
- that directory too.
-
- - It is recommended to use the /lib/udev/devices/ directory to place
- device nodes and symlinks in, which are copied to /dev at every boot.
- That way, nodes for broken subsystems or devices which can't be
- detected automatically by the kernel, will always be available.
-
- - Default udev rules and persistent device naming rules are required by other
- software that depends on the data udev collects from the devices,
- and should be installed by default with every udev installation.
-
-Please direct any comment/question/concern to the linux-hotplug-devel mailing list at:
- linux-hotplug@vger.kernel.org
+ - Udev creates/removes device nodes in /dev, based on events the kernel
+ sends out on device creation/removal.
+
+ - All kernel events are matched against a set of specified rules, which
+ possibly hook into the event processing and load required kernel
+ modules to setup devices. For all devices the kernel exports a major/minor
+ number, if needed, udev will create a device node with the default kernel
+ name. If specified, udev applies permissions/ownership to the device
+ node, creates additional symlinks pointing to the node, and executes
+ programs to handle the device.