- configBase.TitleRow(left, "Retraction")
- c = configBase.SettingRow(left, "Minimum travel (mm)", 'retraction_min_travel', '5.0', 'Minimum amount of travel needed for a retraction to happen at all. To make sure you do not get a lot of retractions in a small area')
- validators.validFloat(c, 0.0)
- c = configBase.SettingRow(left, "Speed (mm/s)", 'retraction_speed', '40.0', 'Speed at which the filament is retracted, a higher retraction speed works better. But a very high retraction speed can lead to filament grinding.')
- validators.validFloat(c, 0.1)
- c = configBase.SettingRow(left, "Distance (mm)", 'retraction_amount', '0.0', 'Amount of retraction, set at 0 for no retraction at all. A value of 2.0mm seems to generate good results.')
- validators.validFloat(c, 0.0)
- c = configBase.SettingRow(left, "Extra length on start (mm)", 'retraction_extra', '0.0', 'Extra extrusion amount when restarting after a retraction, to better "Prime" your extruder after retraction.')
- validators.validFloat(c, 0.0)
+# configBase.TitleRow(left, "Retraction")
+# c = configBase.SettingRow(left, "Minimum travel (mm)", 'retraction_min_travel', '5.0', 'Minimum amount of travel needed for a retraction to happen at all. To make sure you do not get a lot of retractions in a small area')
+# validators.validFloat(c, 0.0)
+# c = configBase.SettingRow(left, "Speed (mm/s)", 'retraction_speed', '40.0', 'Speed at which the filament is retracted, a higher retraction speed works better. But a very high retraction speed can lead to filament grinding.')
+# validators.validFloat(c, 0.1)
+# c = configBase.SettingRow(left, "Distance (mm)", 'retraction_amount', '0.0', 'Amount of retraction, set at 0 for no retraction at all. A value of 2.0mm seems to generate good results.')
+# validators.validFloat(c, 0.0)
+# c = configBase.SettingRow(left, "Extra length on start (mm)", 'retraction_extra', '0.0', 'Extra extrusion amount when restarting after a retraction, to better "Prime" your extruder after retraction.')
+# validators.validFloat(c, 0.0)