3 * Turn on printer and connect computer.
5 cd /home/reprap/reprappro-software.git/
7 * Select "connect" (make sure it's ttyUSB0 115200),
8 wait for printer to connect
9 * Turn on the hotend and bed heaters
10 * Remove MicroSD card from printer and copy the file to it
11 (give it an 8.3 filename ending in .G)
12 * Insert MicroSD card back into printer
13 * Wait for bed (and hotend) to get up to temperature
14 * If there's lots of ooze, pick off nozzle with fine-nosed pliers
15 * "SD" / "Print", select the file you uploaded earlier
16 * Watch while it starts and make sure that the skirt sticks to
17 printbed and nothing gets tangled
18 * Check that filament feed path from feedstock coil looks good.
20 ------------------------------------------------------------
23 ~/.pronsolerc -> /home/ian/things/Reprap/play/pronsolerc (adjust to taste)
30 schroot -pc wheezy openscad
32 Slic3r - is from slic3r-linux-x86-0-9-1.tar.gz
33 /home/reprap/Slic3r/bin/slic3r --load /home/reprap/play/slic3r-config.ini --ignore-nonexistent-config
35 repsnapper - only used this so far for its gcode viewer
37 ------------------------------------------------------------
41 firmware is in marlin.git#iwj and works with make
42 various other firmwares for comparison only
43 sprinter-reprappro.git sprinter.git
45 depends on stuff in arduino-0022 (doesn't work with other arduino
46 versions, incompatible)
48 avrdude -b 38400 -v -P /dev/ttyUSB0 -p atmega644P -c arduino -U flash:w:Marlin.hex
49 needs the reset jumper (which is right next to the mcu) fitted