get_user_pages — pin user pages in memory
int get_user_pages ( | struct task_struct * tsk, |
| struct mm_struct * mm, | |
| unsigned long start, | |
| int nr_pages, | |
| int write, | |
| int force, | |
| struct page ** pages, | |
struct vm_area_struct ** vmas); |
tsktask_struct of target task
mmmm_struct of target mm
startstarting user address
nr_pagesnumber of pages from start to pin
writewhether pages will be written to by the caller
forcewhether to force write access even if user mapping is readonly. This will result in the page being COWed even in MAP_SHARED mappings. You do not want this.
pagesarray that receives pointers to the pages pinned. Should be at least nr_pages long. Or NULL, if caller only intends to ensure the pages are faulted in.
vmasarray of pointers to vmas corresponding to each page. Or NULL if the caller does not require them.
Returns number of pages pinned. This may be fewer than the number
requested. If nr_pages is 0 or negative, returns 0. If no pages
were pinned, returns -errno. Each page returned must be released
with a put_page call when it is finished with. vmas will only
remain valid while mmap_sem is held.
Must be called with mmap_sem held for read or write.
get_user_pages walks a process's page tables and takes a reference to each struct page that each user address corresponds to at a given instant. That is, it takes the page that would be accessed if a user thread accesses the given user virtual address at that instant.
This does not guarantee that the page exists in the user mappings when get_user_pages returns, and there may even be a completely different page there in some cases (eg. if mmapped pagecache has been invalidated and subsequently re faulted). However it does guarantee that the page won't be freed completely. And mostly callers simply care that the page contains data that was valid *at some point in time*. Typically, an IO or similar operation cannot guarantee anything stronger anyway because locks can't be held over the syscall boundary.
If write=0, the page must not be written to. If the page is written to, set_page_dirty (or set_page_dirty_lock, as appropriate) must be called after the page is finished with, and before put_page is called.
get_user_pages is typically used for fewer-copy IO operations, to get a handle on the memory by some means other than accesses via the user virtual addresses. The pages may be submitted for DMA to devices or accessed via their kernel linear mapping (via the kmap APIs). Care should be taken to use the correct cache flushing APIs.
See also get_user_pages_fast, for performance critical applications.